Battery Emulator
Software: 9.0.RC8 Hardware: LilyGo T-CAN485 @ 47.8 °C Uptime: 0 days, 2 hours, 32 minutes, 41 seconds SSID: Kowalczyk RSSI:-84 dBm Ch: 12 Hostname: esp32-A85680 IP: 192.168.178.117
Inverter protocol: BYD 11kWh HVM battery over Modbus RTU Battery protocol: Fake battery for testing purposes
SOC: 50.00% SOH: 99.00% Voltage: 333.0 V Current: 0.1 A Power: 33 W Total capacity: 93.0 kWh Remaining capacity: 61.0 kWh Max discharge power: 6.0 kW Max charge power: 6.0 kW Max discharge current: 18.0 A (BMS) Max charge current: 18.0 A (BMS) Cell min/max: 3500 mV / 3596 mV Cell delta: 96 mV Temperature min/max: 15.0 °C / 17.8 °C System status: OK Battery charging! (Inverter limiting) Power status: RUNNING Emulator allows contactor closing: ✓ Inverter allows contactor closing: ✓
Contactors not fully controlled via emulator [?] This means you are either running CAN controlled contactors OR manually powering the contactors. Battery-Emulator will have limited amount of control over the contactors! Pause charge/discharge Perform OTA update Change Settings More Battery Info CAN logger CAN replay Log Cellmonitor Events Reboot Emulator Open Contactors